1/4" Tank Connector | Two Wests
When using an overhead tank to supply water in a ¬" Drip Watering System use this Tank Connector to allow you to attach ¬" tubing directly to the tank.
The robust Tank Connector is simply to install. Unscrew the Tank Connector so that you have three separate parts ready to fit:
A - a 2" (5cm) long screwed fitting which should be fitted through the side or base of the tank after drilling an 11mm hole (you will need access to the inside of the tank in order to fit this).
B - rubber washer to fit onto the outside of the tank.
C - screw fitting to attach back to the Tank Connector of the outside of the tank, screw tight up to the washer for a secure connection.
You are then ready to fit the ¬" tubing to the barbed fitting at the end of the Tank Connector.
We supply all the components necessary for you to design your own ¬" Drip Watering System to meet your exact requirements.
For successful operation of a ¬" Drip Watering System the water supply should be at a low & even pressure - using an overhead tank or a 2 Gallon Bag is a suitable source.